# How much memory to allocate to the GPU, minimum is 16.
gpu_mem=128

# Uncomment and set gpu_mem to 128 if you want to use the Pi camera module.
#start_x=1

# Uncomment one of the following blocks to overclock.

# None
#arm_freq=700
#core_freq=250
#sdram_freq=400
#over_voltage=0

# Modest
#arm_freq=800
#core_freq=250
#sdram_freq=400
#over_voltage=0

# Medium
#arm_freq=900
#core_freq=250
#sdram_freq=450
#over_voltage=2

# High
#arm_freq=950
#core_freq=250
#sdram_freq=450
#over_voltage=6

# Turbo
#arm_freq=1000
#core_freq=500
#sdram_freq=600
#over_voltage=6

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

# for more options see http://elinux.org/RPi_config.txt

# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=audio=on
dtparam=random=on
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Uncomment this to enable Eric Anholt's DRM VC4 HDMI/HVS/V3D driver
#dtoverlay=vc4-kms-v3d

# Additional overlays and parameters are documented in /boot/overlays/README
